| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > PCB Rework and Repair Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Rework or not Rework?

Date: 01/03/02 at 11:05 AM
Posted by: Peter Swanson
E-mail: peter.swanson@dynamixtechnology.com
Message Posted:

In Reply to: Rework or not Rework? posted by Jim Truelove on 09/12/01 at 5:31 AM:

Regardless of the response from the previous poster, blow-holes are not necessarily a cause for touch-up. It does depend on the type of product which you are building.

I suggest that you review some industry standard workmanship documents; start from there and append as necessary. The most widely used is probably IPC-A-610; more info at http://www.dynamixtechnology.com/ipcassem.htm.


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.